Re: [StrongED] Swapping versions

[Fred Graute <fjgraute@xxxxxxxxx>]

In message <5706a14ebdLists@xxxxxxxxxxx>
          "Richard Torrens (lists)" <Lists@xxxxxxxxxxx> wrote:

> I have been checking instructions against StrongED 4.70 but Fred advises
> me to check against 4.69. This involves being able to swap!

My main point was that the instructions should be suitable for 4.69 as
not everyone will be using 4.70 so describing features new in 4.70 may
cause confusion.

> So I have written a script. It's at
> http://stronged.torrens.org/man/examples/swap.html

It seems some escaping is needed around <SE$this> and <SE$next>.

There is simpler way of doing this. If you have StrED_cfg next to
StrongED then you can simple install another version of SE along with
its own StrED_cfg. You can run either version or even both versions at
the same time.

If StrED_cfg is in Boot:Choices then it's a bit more complicated. The
easiest solution is to move StrED_cfg into the same directory as SE
(the one that you run normally). Then as per above paragraph.

If you want to keep StrED_cfg in Boot:Choices then you need to be very
careful. For each extra version of SE you'll need to put StrED_cfg next
to it. You start your main version normally but any other version needs
to be run by Ctrl-doubleclick to force the use of the local StrED_cfg.

Cheers,
Fred.

-- 
StrongED Developer
http://www.stronged.iconbar.com/

-- 
To unsubscribe send a mail to StrongED+unsubscribe@xxxxxxxxxxx
List archives and instructions at
http://stronged.torrens.org/index.html